George a quick (possibly dumb) question about the fuel lines again..........it appears my pickup tube is 1/2" ID (all good there) but the elbow fitting
connects the pickup and then the fuel line out has a smaller female dia. thread inside............I'm thinking 3/8" or as small as 1/4" not sure.
I might have to scrap something here to make everything uniform...........what good would a 1/2" pickup tube be if it's going through restriction at
the smaller ebow passage..............shouldn't everything be uniforn?...........in other words, if #-8 fuel line is used shouldn't that size dia. carry through all the hose fittings.?...........Also, I have an aluminum tank so should only aluminum fitting be used? ....this has taken so much of my time it's silly!