Results 1 to 2 of 2

Thread: Corsa Marine 4" Inline Exhaust Flapper

  1. #1
    Join Date
    Jul 2003
    Posts
    299
    Rep Power
    21

    Corsa Marine 4" Inline Exhaust Flapper

    Corsa Marine 4" Inline Exhaust Flapper

    These are a very good quality inline flapper and made to go inside of a 4" exhaust hose. Everyone with thru hull exhaust should have these. All engines should have 2 methods of preventing water from entering the engine exhaust. These are standard equipment on all Hornets with thru hull exhaust. These are to be used in conjunction with tips with built in flappers. They are all stainless steel with a high temp rubber coated flapper that makes them quite and brvides a better seal.

    They are installed by sliding into your exhaust hose upstream of the thru hull and then just put one hose clamp in the outside of the hose to hold in place.

    These are imperative on boats that sit a little low in the transom and get high water when coming off of plane.

    These are a universal fit for any 4" exhaust hose but changes in our design have left us with a few extra sets of these

    They are sold by the pair

    http://www.ebay.com/itm/131174780276...84.m1555.l2649

    I just listed them and have a few sets. No Reserve.

    If you have thru Hull exhaust I can not recommend these enough
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	Inline flapper 2.jpg 
Views:	92 
Size:	104.6 KB 
ID:	79408   Click image for larger version. 

Name:	Inline Flapper back.jpg 
Views:	111 
Size:	111.3 KB 
ID:	79409   Click image for larger version. 

Name:	Inline Flapper front.jpg 
Views:	165 
Size:	121.3 KB 
ID:	79410  

  2. #2
    Join Date
    Jul 2003
    Posts
    299
    Rep Power
    21

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •