SOLD -Mercruiser Alpha One Gen 2 by SE Engineering

[ACE51]

SE Engineering SE116 which is the same as a Mercruiser Alpha One Gen 2 (1991 Alpha-present) with Mercruiser stickers/graphics. Good working condition. No salt water use. Free local pickup in Winston Salem, NC (27106) or AOTH. 1.62 Gear ratio standard RH drive. Will ship with upper/lower separated at cost if needed. $675. New is $1,500 without driveshower/skeg.

Email me for best contact: aaronelsner@aol dot com.

[BUIZILLA]

I am VERY interested.... why the skeg guard? how many hours?

[ACE51]

I am VERY interested.... why the skeg guard? how many hours?

This unit came on the 16 when I bought it, I believe it has ~75-100 hours on it (might be less). GOLDNROD replaced the factory Mercruiser unit (not sure if that one blew up or if he hit something) with this one and added the skeg guard and drive shower.

[BUIZILLA]

if the skeg is intact under the guard I'll take it.

thanx

[ACE51]

If you know a way I could remove these one way flat head screws I would remove the skeg! Also attached is a picture of the bottom drain plug as removed this AM, not much crud on it.

[BUIZILLA]

the last one I took off I had to use a 3/16 wide blade cold chisel against the screw ramp and they came right out...

[biggiefl]

WHy not just leave it on, aint worth anything used.

[ACE51]

I tried with a BFSD with no luck of removing those screws, even if you take off the skeg there will still be the two holes from the screws. I supposed you could PM goldnrod and ask him why he put it on? I think it looks cool. Let me know if you want it!

[BUIZILLA]

i'll take it, PM me please

[gold-n-rod]

The skeg is intact. I put the guard on it when the drive was new.

Randy

[BUIZILLA]

good to hear that...

this is a spare for my deckboat... anxious to try the 1.65 ratio on my Blender Barge...

the last excursion thru the Dora Canal in my 16 just cost me $952 in repairs on the TRP Yammi...

[ACE51]

cleaning up all my FS adds, this one is also ​sold