I'm getting ready to split the deck on my 1970 18 2+3 and I have a few questions...
-What's this about fiberglass tabs that need to be cut?...where are they?
-Once the boat is split and disassembled, how do I flip the hull over?
Thanks!
Aaron
I'm getting ready to split the deck on my 1970 18 2+3 and I have a few questions...
-What's this about fiberglass tabs that need to be cut?...where are they?
-Once the boat is split and disassembled, how do I flip the hull over?
Thanks!
Aaron
1974 Magnum 27 Sport
1970 Donzi 18 2+3
There are tabs on the ski locker on both sides, one on the very front of the locker. Also there are tabs on the sides where the locker meets the tub. Also tabs are in the area where the center storage locker is.
Get a few friends to help flip the hull. Its easy.
I haven't flipped a Donzi that small, but a few folks probably can do it easily.
It's always a good idea to bolt in some reinforcement between the gunnels.
George Carter
Central Florida
gcarter763@aol.com
http://kineticocentralfl.com/
“If you have to argue your science by using fraud, your science is not valid"
Professor Ian Plimer, Adilaide and Melbourne Universities
Cool. Will the hull be okay on boat stands until I can get some 2x4s in for bracing?...or should I put it back on the trailer?
Any problem with pulling the motor after the deck is off?...or should I do it before?
1974 Magnum 27 Sport
1970 Donzi 18 2+3
To tell you the truth the boat ( hull ) will be just fine on boat stands considering you are planning on flipping the hull within the next few days or future .which should not distort the hull or shape at this time (unless it is a lengthy period of time ) but to tell you the truth i have flipped 46 Skaters ....adding pads to the bottom with not much support to the hull other then Bulkheads for more then a few weeks ..................
If your doing transom work or stringer work you better make a jig.
There are currently 1 users browsing this thread. (0 members and 1 guests)