Need to fab some custom elbows for my aftermarket exhaust. Going to buy 316L Stainless tubing for the project, but have no idea what the wall thickness should be . Would this suffice?
Need to fab some custom elbows for my aftermarket exhaust. Going to buy 316L Stainless tubing for the project, but have no idea what the wall thickness should be . Would this suffice?
Double wall to allow passage of cooling water?
RedDog
President - West Vestal Donzi Owner's Group
Knoxville, TN
Single wall- wet exhaust
Wet exhaust elbows are double walled, the water has to be injected at the end of the elbow so to prevent revision.
Donzi 18C
Donzi 25 ZX "Full Tilt F/B "
Is this only when using stainless elbows? I'm using Imco Thumper Power manifolds....water mixes with exhaust at the back of the riser as it exits. Do I still need double walled elbows in this case?
I'm holding a Stainless Marine Elbow in my hand and it's measureing 7/64" thick
DUNESMAN
Thanks guys, I think I found something thicker than that .065 which should work.
There are currently 1 users browsing this thread. (0 members and 1 guests)