Registered User
I am getting ready to reinstall my B1 and have a quick question about greasing. I have the newer (non-zerk) U-Joints, so I assume if they feel good to leave them alone? Also, where do I grease the gimble? Is there a zerk inside the engine compartment? I don't have one on my transom assembly, so is it inside the bilge area?
Donzi 18C
Donzi 25 ZX "Full Tilt F/B "
Boating Enthusiast
I have one Bravo where the gimbal grease fitting is in the engine compartment (I think on top at the back) and another that is on the outside transom assembly stbd side. Bill
1971 Donzi 18' 2+3
1985 Eliminator 23' Daytona Offshore - Kevlar hull
1988 23' Donzi CC F-23 with 250HP EFI Mercury OB
1989 28' Team Warlock Offshore - single 548CID/600HP
1990 23' Warlock Offshore - single 525HP
Bill from Denison, TX - Lake Texoma
Registered User
Thanks Bill, what grease do you like to use on that?
Donzi 18C
Donzi 25 ZX "Full Tilt F/B "
Paid Subscriber
The grease fitting for the Gimbel is outside on the right hand side of the shield, it is the only fitting the late models have.
Phil
No matter what your beliefs are "GOD BLESS AMERICA"
Fully retired marine tech near 60 years in the biz.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote