Can anyone tell me how the rear seat back and side pieces come out of a 25zx. Please tell me I don't have to remove the firewall!!! Getting the vinyl redone and need to know how it comes out.
Thanks!
Can anyone tell me how the rear seat back and side pieces come out of a 25zx. Please tell me I don't have to remove the firewall!!! Getting the vinyl redone and need to know how it comes out.
Thanks!
How do you get the bottom out, I took out the 4 or 5 screws and thought it would slide forward, it seems to be attached at the inside front corner of each square side pad, any ideas.
I noticed on mine that where the rear piece and the side piece meet, there is a screw hidden in the seam, but i don't know how the rear is tied into the firewall....
Anybody have any ideas...I'm going to tear into this thing this weekend.
My 28 has like automotive plastic push in fastners that pull out with a V shaped pry tool
Well I tackled the interior today....what a PITA!!! rear section was bolted to the fiberglass. only way to reach the nuts without a go-go gadget arm was to remove the firewall. Only way I could see to remove the firewall was to pull the engine! Ended up using a hole saw and cutting (3) 4-1/2" holes in the fire wall. Going to get some deck plates to fill the holes.
Sides were not as bad, but still a PITA. Couldnt reach the last bolt beside the throttle and ended up sawing it off with a hacksaw blade. going to require A LOT of patience to get it back in.
There are currently 1 users browsing this thread. (0 members and 1 guests)