Quote Originally Posted by mphatc View Post

George,

Thank you . . . 7.2" isn't that bad to blend . . .I'm also considering gussets from the hull to the transom, two on each side.
These would be perpendicular to the 24 degree surfaces one up each side of the drive mounting surface . . thoughts??
Mario L.
Mario, darn computer doesn't have a "DEGREE" symbol, so I used an asterisk instead. That was 7.2 degrees of angle. There's really not that much difference though. If your transom is also 9/16" thick, the scarf will be about 6 3/4".
That 3/4" bottom opening is 9" wide.
Bummer!