Simply put, the octane rating of the fuel reflects the ability of the
unburnt end gases to resist spontaneous autoignition under the engine test
conditions used. If autoignition occurs, it results...
Type: Posts; User: kcatucci; Keyword(s):
Simply put, the octane rating of the fuel reflects the ability of the
unburnt end gases to resist spontaneous autoignition under the engine test
conditions used. If autoignition occurs, it results...
For some reason i think i remember reading the same description last year some time.
I have never stuffed the Minx.
In 79/80 i had an 18' Starcraft. I used to take water over the bow all the time on purpose. The way the windshield was, the water came across the bow, up the...
I used a product called 'Goo Gone" to remove all the decal glue from a jet ski. You can get it at Home Depot.
Tried several props on my 86 minx. Cleaver was the best.
that looks like a teak gang plank.
I am on my second season on my SEI drive without an issue.
I never pull a hole shot, however my motor is turning 5k or more 90% of the time.
I tried a mirage on my Minx and put the cleaver back immediately.
I cant see your profile for some reason but that looks alot like a minx and alot like the hudson river near apline.....
Surprised I have not seen you out there.
What could be more permanent than a temporary fix?
I would get a new pump over niight.
Look at the bright side. Great fuel economy! :)
350 .30 over. Aluminum heads and intake, ported, polished, matched. 10 to 1 compression. Blueprint 5 angle valve job. Mahle pistons. Manley springs and stainless valves. Crower stainless roller...
I had something similar happen that taught me a valuable lesson.
I was driving a sea doo speedster with twin 85's. While turning hard to port at about 50 the port engine died. The boat went into a...
I would be sick to my stomach putting holes in my Donzi.
Where near NYC?
I got my Minx brand new in 1986. Before I changed the motor it was 62+/- every time.
FWIW, I broke a fuel pump in my Minx. The engine ran rough and smoked, but it ran thru the full rpm range. The vent on the marine fuel pump was sending engine oil into the carb. Obviously the pump...
My Stellings are on aluminum heads. When I got them I had to have the stainless flange notched as much as i could but it still wasnt enough so I bought a deep socket and cut half of the center out...
I cant vote!
I have one of the very few Stellings built for small block.
Hideous is the right word.
B O A T = Bring On Another Thousand
I have had a set of Stellings in the Minx since 1991 and have not experienced any cracking. <knocking on desk>
Where are the pics?
pricing on the hd gear set and required tools would be great. thanks
Well I got it all opened up. The upper gears are a total wipe out. Anyone know how difficult it is to change them?