View Full Version : 351 H/M Exhaust Manifolds
donzidon
09-27-2016, 12:24 AM
I have an X-18 with a 351 H/M Volvo 280 package.
The motor failed, and I built up a new 351W unit.
However, I can't get the Redline exhaust manifolds I have to seal properly at the riser gasket.
I am looking for replacements and don't know what to use.
Both Redline and Hi-Tek are out of business.
Stainless Marine does not support Ford products.
Any advice would be much appreciated.
Thanks,
Don
woobs
09-27-2016, 07:38 AM
Hi Tek is not out of business. Rather, the business is for sale...
They are still producing exhaust systems.
mattyboy
09-28-2016, 09:55 AM
Hi Tek is not out of business. Rather, the business is for sale...
They are still producing exhaust systems.
they had a few businesses/dealers is this the Stateside co. or the down under co.?
mattyboy
09-28-2016, 09:59 AM
depending on how hot your motor is center risers may work from barr Osco indmar may be a choice as well
http://www.cpperformance.com/p-13919-small-block-ford-with-aluminum-riser.aspx
or there is always a custom set from $$$$$$ CMI $$$$$$$$$$
woobs
09-28-2016, 07:22 PM
they had a few businesses/dealers is this the Stateside co. or the down under co.?
I e-mailed Allen (the owner of Hi-Tek in Australia). His response:
"Hi Sean,
We're still open for business ,I don’t know who would have said that. If you can, can you get rid of that for me . I only have it for sale as I am 72 and I have been doing it for 25 years its someone else's turn.
Regards,
Allen."
mattyboy
09-28-2016, 07:33 PM
Woobs thanks
good info
this is the American company not sure if they are still around
http://american-hi-tek.com/
woobs
09-28-2016, 10:47 PM
They are probably a dealer/distributor. Although looking at their products, they may be an entirely different company.
At any rate, I always deal direct with Australia (and save) :)
donzidon
10-05-2016, 08:54 PM
I will contact HiTek and look into Barr.
Very much appreciate the advice and research.
- Don
mattyboy
10-06-2016, 07:20 AM
the hi teks look the best by far, if the motor is not really warmed up the barr should be fine
http://bpi.ebasicpower.com/search_2/show.php?q=volvo+manifold
geage
10-15-2016, 06:09 PM
I got hi teks For my ford from Allen a few years ago. Real nice guy and they where at my door in 2 weeks. And are Wickid nice
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.