22 bottoms you think are straight .. until

[Inferno]

I could have sworn that the bottom was perfect, until over 100 hours on blueprinting it ... Now time to put the new motor in .

[gcarter]

Yep, they change all the time. Mine would change w/the temperature ,
and for no reason at all.
I finally got frustrated and called it good.
It was definately better than original.
There's nothing stable about fiberglass.
And my bottom is about 1" thick.

[Lenny]

Can't wait to see the results this time with a leaner engine, 1250 hp and a pad. A ride in this is going to be on my bucket list, plane ticket to Tennessee in the spring for sure !!!

Looks great Stan. The project is definatly a beast. The new IMCO SCX4 drive will also be interesting.

If you ever want to throw a dime or two into my cup let me know. I'll shoot you an email and let you know where my next " homeless" corner will be :) I'll bring a guitar and a trained monkey.

Keep it going !!!

Fantastic !

[Ghost]

Looks great, Stan--can't wait. :)

[JParanee]

More pics please

[mike o]

GP resin + high air temps = resin shrinkage caused by 2 much exotherm on thick FLAT surfaces during lay-ups. But ever on a radius :yes:

[glashole]

nice name drop Mike