PDA

View Full Version : Anyone have bravo tools?



yeller
07-28-2015, 12:45 PM
Posting this on both sites as well as OSO

I need to set up the gear lash on my drive, but I don't have the "stub shaft" tool that hold the gears and the gear lash flag. It would be well over a week to get the tool...and it's over 3 weeks to get into any shop to have them do it.

I can set up the lash using the yoke, but I need to know the diameter of the shaft tool where the gear lash flag is mounted. If I have that measurement, I can calculate what my lash should be.

Also...anyone have an alternative to merc 1x u-joints?

Anyone have the tool to measure?
Thanks in advance.

yeller
07-29-2015, 12:11 AM
Got the measurement.