View Full Version : seals on a Volvo AQ
mattyboy
05-21-2014, 07:48 AM
if the seals on the drive leg were going bad and letting water into the gear oil wouldn't gear oil leak out as well??
trying to isolate the seal that has failed if it is a lower one like the shifter seal or prop shaft seal would oil leak out ?? I thought it may be the dipstick washer but not sure now
any leads would be helpful
Thanks
Conquistador_del_mar
05-21-2014, 11:06 AM
Matty,
If you can get a little air pressure (10PSI?) to the top fluid level inspection hole with the prop off, I would think that would at least determine if it is the prop shaft seal which is such a common problematic seal. You might have a groove in the prop shaft where the seal has ridden for many years. My two cents, Bill
Just Say N20
05-21-2014, 11:43 AM
My prop shaft seal let water into the drive oil, and it was leaking a little oil on the ground, running down the skeg.
mattyboy
05-21-2014, 07:52 PM
Thanks guys I will try that
tiupc
05-22-2014, 04:47 PM
My AQ280 leaks oil behind the shift inspection cover. I suspect it is the shift cable seal as I have replaced the fill, vent and drain washers. How do you change the shift cable seal From the front or the back of the drive ?
Trevor
mattyboy
05-22-2014, 04:52 PM
that seal is a PITA it is behind the shift flange I'll see if i have a diagram
mattyboy
05-22-2014, 04:59 PM
Tiupc
page 64 of the printed manual and page 67 of the pdf
AQ workshop manual courtesy of the LGDCC (http://www.lgdonziclassic.com/pdfs/AQWSM.pdf)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.