View Full Version : Solas 23 re pitch
Ralph Savarese
03-23-2014, 01:17 PM
Can a solas 23 be repitched seems like a very strong rigid prop to bend
mattyboy
03-23-2014, 01:19 PM
what numbers are you turning the 23 to now?
Ralph Savarese
03-23-2014, 01:29 PM
I am not just wondering what would you do if 23 is not enough on big power engines
mattyboy
03-23-2014, 07:32 PM
It takes 400 plus hp to turn a Solas 23 to the mid 5 g's with 1.6 gears.
I would get the 23 and run it then see what you have. You could always pick up the hm 1.3 lower on eBay
The Solas is a good prop right out of the box a lot of time and resources went into it so you are not going to tweak a lot more out of it
The real numbers run out to a prop that is 1-2 inches bigger than 23
Just Say N20
03-24-2014, 06:15 AM
Ditto to what Matty said. Unless you are talking BIG power as in over 500, run it first and see where you come out.
If you can spin it to over 5,000 and the drive is not too deep, you should be over 70.
f_inscreenname
03-24-2014, 10:44 PM
To answer the original question, it's gonna cost ya.
I had this eBay prop reworked for my Biesemeyer,
http://imageshack.us/a/img580/3410/we3c.jpg
to this,
http://imageshack.us/a/img59/1452/6zmn.jpg
at a pretty reputable and well known prop shop. Cost was about 130.00 each and well worth it. When I picked them up I asked about my Solas 23 left. After they explained what they had to do plus re hubing it because of the heat and such cost was about what I paid for the prop (330.00). So like said, make sure it is what you want to do before you do it.
Fishermanjm
03-25-2014, 11:22 AM
just wondering... what does the two blade prop go on?
Ghost
03-25-2014, 12:27 PM
The Bies I think...
I had this eBay prop reworked for my Biesemeyer,
f_inscreenname
03-25-2014, 01:19 PM
just wondering... what does the two blade prop go on?
Like Ghost said,
http://www.supernova19.com/resurrectionmarine/1c4b3fe0.jpg
Both props are for the same boat. Got them both done at the same time.
Fishermanjm
03-25-2014, 04:30 PM
That is cool!!!
Ralph Savarese
03-27-2014, 06:47 PM
So I guess the answer is the biggest you are going to get for a Volvo 280 is a solas 23
mattyboy
03-27-2014, 07:37 PM
yes in a solas
it is hard to explain until you run one the are very efficient and grip the water well , they handle well . I don't know anyone running one on a sharp keel barrelback but they run well on other style classic hulls.
what numbers are you running now with your best prop . if your turning a 24 pitch ultra to 5400 rpm you'll lose 200-400 rpm dropping to a 23 solas
I had a 310 hp 351 with plenty of torque and it could not turn a 23 solas on 1.6 it could turn a 21 solas to 4900 rpm I could spin a 22 ultra well past 5000 rpm
you can try and find a 26 ultra but the solas will perform better
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.