View Full Version : 28 ZX hatch actuator problems
Alladin
07-13-2013, 04:35 PM
I had the original factory acculift actuator and after a while I found it was very slow to the extent that I had to help it manually to even open the sundeck. So I concluded it was giving up and I went out and bought a new hardin marine from cp performance. Installed it and I still need to help it manually to open the sun deck. Now I'm clueless, what is wrong. Is there a factory relay that could have gone bad? Anyone with any ideas?
GeneD
08-12-2013, 05:37 PM
It certainly sounds as if you are experiencing a power problem.
Could be a bad ground, or bad power lead.
Using a meter, see if you're actually getting 12v to the unit.
Try using a jump wire to ground...get inventive.
Trueser
08-15-2013, 07:32 AM
Is the hatch / Foam full of water? can you lift it by hand?
is the battery 12 volts or greater?
With the motor running is it the same issue?
That cover is heavy.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.