View Full Version : Donzi 16 Prop Recommendations?
BOSTONCAMARO
04-01-2013, 05:55 PM
Ok so I have a 1990 Donzi 16, OMC drive, Ford 302, 2 barrel motor...it is totally stock and I want good all around performance and some wakeboard pulling. Recommended RPM in the owners manual is 4000 - 4400 RPM.
The prop that was on the boat when we got it is a three blade stainless steel prop
Stiletto 20-321-01421 14.25 inch X 21 pitch
I also have two other props
OMC 391290 15 inch X 17 pitch
OMC 391200 15 inch X 17 pitch
And also have the chance to get a 15 inch by 15 pitch OMC part number 174926
I appreciate any and all help!
Thanks, Tim
What is your WOT RPM now with the 21? I had a 21 on my 90 16 with a 302.
Phil
BOSTONCAMARO
04-02-2013, 08:02 AM
What is your WOT RPM now with the 21? I had a 21 on my 90 16 with a 302.
Phil
I am not sure offhand....thinking I should stick with the 21 pitch for now?
I tached out close to 5000 trimmed out.
Phil
BOSTONCAMARO
04-02-2013, 10:11 AM
and you had no issues? so maybe I should run the Stiletto 21 for now? thanks
THEDONZ33
04-02-2013, 12:46 PM
I am running a 21 Vengence on my 16 with a 5.7L 350 260 Hp Merc. After trialing SEVERAL other 3,4 abd 5 bladed wheels. 19 -23 pitch.
The Vengence gave me the BEST ride, handling, hole shot and mid rangesthrottle responce and general over all great performance. I am running nearly a 56mph and 48-5100 rpm pending conditions.
BOSTONCAMARO
04-02-2013, 02:35 PM
My Stiletto 21 has a couple minor dings, so I think for now, I will drop it off, have it trued up
thanks for the recommendations!
ACE51
04-02-2013, 07:41 PM
Here goes my salesman post :)
I don't know the dimensions on the Stiletto but I have two props in the FS section that I ran on my 16, one is 14.75 and is a 21P, I picked up about 2 MPH going from a Turbo 1 with this prop.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.