PDA

View Full Version : Trailer Hub Question/Help



Scott Pearson
08-27-2012, 10:34 AM
Ok...so how tight or loose should they be? Whats the best way to know they are adjusted right. I just put a new rear axle and bearings in my trailer and repacked the front axle bearings. Just not real sure on if I have it adjusted correctly.

Thanks!!

John C in PA
08-27-2012, 10:48 AM
Loosen the large nut to finger tight, then slowly tighten this nut with a wrench while slowly spinning the wheel. Stop tightening the nut when the wheel starts to drag. This assures that you seated the bearing in the race. Loosen the nut 1 flat, install the cage over the nut, and then the cotter pin. Go boating!!!! :lookaroun:

John C

undertaker
08-27-2012, 02:17 PM
Pearson stop being so cheap and just buy a new trailer.....WTF