PDA

View Full Version : Camshaft selection.



XMETAL
07-07-2012, 08:56 PM
So it looks like the Minx I'm going to pick up the end of summer needs an engine. I have a SBC that I'm going to build up. I'm looking to get about 400hp out of it on pump gas. I have everything but the pistons and a cam. Also I'm using a set of 202 Fuelie heads with 64cc chambers. Im only looking to run on pump gas. Thanks in advance.
Steve

BUIZILLA
07-08-2012, 06:32 AM
Fix ...... Flat pistons with 64cc iron heads ?

XMETAL
07-08-2012, 01:23 PM
[ QUOTE=$originalposter]{$pagetext}[/QUOTE]

So basically this will be a 383 stroker then?.... Did you dyno your engine when you did this?

BUIZILLA
07-08-2012, 03:05 PM
So basically this will be a 383 stroker then?.... no, it will be a long rod 350...

MOP
07-09-2012, 05:50 PM
My 383 has 6" rods, -0- deck with flat tops. My heads are 72cc Dart Iron Eagles, my CR is 9:125 it runs better on 87 than 93. IMO you will need a fair dish with 64's, or resort to av gas.