BOSTONCAMARO
06-28-2012, 08:35 PM
Ok, so my boat is an OMC, Ford 302. I need to do a few little things to get everything up to par before putting it in the water in two weeks, we are pretty handy, do a lot of restoration work on early Camaros and Corvettes, build motors, trans, etc, so really not too concerned about the labor involved but would really appreciate the advice from you guys on where to start. All of the information I have received from you guys on here has been great.
Bilge Pump - is not working at the switch, I want to pull it to test..then replace if needed, is it located down below the oil pan in the rear of the boat?
Tilt Gauge - the tilt works great, no problem at all but the guage is not working, we did notice a steel cable that appears to be a ground cable that goes into a bolt on the out drive, is this a ground cable for the tilt gauge? if not, what may it be?
Service Manual - what is a good source for picking up a quality print version of a service manual?
Regards, Tim
Bilge Pump - is not working at the switch, I want to pull it to test..then replace if needed, is it located down below the oil pan in the rear of the boat?
Tilt Gauge - the tilt works great, no problem at all but the guage is not working, we did notice a steel cable that appears to be a ground cable that goes into a bolt on the out drive, is this a ground cable for the tilt gauge? if not, what may it be?
Service Manual - what is a good source for picking up a quality print version of a service manual?
Regards, Tim