PDA

View Full Version : Stainless Exhaust Elbow Thickness?



DonziDan16
05-29-2012, 02:55 PM
Need to fab some custom elbows for my aftermarket exhaust. Going to buy 316L Stainless tubing for the project, but have no idea what the wall thickness should be :bonk:. Would this (http://www.ebay.com/itm/Stainless-Steel-316L-Round-Tubing-3-OD-0-065-Wall-12-Length-/140654809642?pt=LH_DefaultDomain_0&hash=item20bfae122a) suffice?

RedDog
05-29-2012, 04:13 PM
Double wall to allow passage of cooling water?

DonziDan16
05-29-2012, 04:23 PM
Single wall- wet exhaust

Mckillop
05-29-2012, 04:41 PM
Wet exhaust elbows are double walled, the water has to be injected at the end of the elbow so to prevent revision.

DonziDan16
05-29-2012, 06:11 PM
Is this only when using stainless elbows? I'm using Imco Thumper Power manifolds....water mixes with exhaust at the back of the riser as it exits. Do I still need double walled elbows in this case?

pipnit
05-30-2012, 12:39 PM
I'm holding a Stainless Marine Elbow in my hand and it's measureing 7/64" thick

DonziDan16
05-31-2012, 03:11 PM
Thanks guys, I think I found something thicker than that .065 which should work.