PDA

View Full Version : How to remove zx interior



tnc110
03-05-2012, 05:59 PM
Can anyone tell me how the rear seat back and side pieces come out of a 25zx. Please tell me I don't have to remove the firewall!!! Getting the vinyl redone and need to know how it comes out.

Thanks!

ROADTOYS
03-06-2012, 10:59 AM
How do you get the bottom out, I took out the 4 or 5 screws and thought it would slide forward, it seems to be attached at the inside front corner of each square side pad, any ideas.:confused:

tnc110
03-06-2012, 08:55 PM
I noticed on mine that where the rear piece and the side piece meet, there is a screw hidden in the seam, but i don't know how the rear is tied into the firewall....

tnc110
03-14-2012, 08:43 PM
Anybody have any ideas...I'm going to tear into this thing this weekend.

ROADTOYS
03-15-2012, 10:20 AM
My 28 has like automotive plastic push in fastners that pull out with a V shaped pry tool

tnc110
03-17-2012, 06:50 PM
Well I tackled the interior today....what a PITA!!! rear section was bolted to the fiberglass. only way to reach the nuts without a go-go gadget arm was to remove the firewall. Only way I could see to remove the firewall was to pull the engine! Ended up using a hole saw and cutting (3) 4-1/2" holes in the fire wall. Going to get some deck plates to fill the holes.

Sides were not as bad, but still a PITA. Couldnt reach the last bolt beside the throttle and ended up sawing it off with a hacksaw blade. going to require A LOT of patience to get it back in.