mphatc
01-08-2012, 09:13 PM
These came off my 1968 Magnum 27
Two Volvo 250 drives. One died the last time out, and when turned over by hand there is noise and crunchy sounds from within.
The second drive functioned normally when removed.
These were not used for 14 years, and I only ran them 10 hours. They were used in salt water , but did not have corrosion as they had been painted with Graphite based antifouling paint and the boat was a trailerd boat.
Just prior to removing these drives I completely stripped these to bare metal, primed with Dupont Epoxy and refinished in White polyurethane. The upper bearings were replaced, both drives were resealed on the top with new u-joints installed on the CV joint assemblies.
Transom plates
Aluminum bellhousings to fit Chevy engines
Intermediate housings, (I have the bearings to rebuild these and can sell as rebuilt for additional $)
Also available are several tilt motors , I believe I have 4 or 5 of these.
Pictures here:
http://www.donzi.net/forums/attachment.php?attachmentid=51118&d=1254064306
All components available in any way that some one desires. Need the space!
I only replaced these as I found a set of 280 drives with power trim.
I am able to ship and accept credit cards, Pay Pal is preferred.
Please contact me directly via email!!! Mario@VSR1.com
or call at 603-228-2888
Mario L.
Two Volvo 250 drives. One died the last time out, and when turned over by hand there is noise and crunchy sounds from within.
The second drive functioned normally when removed.
These were not used for 14 years, and I only ran them 10 hours. They were used in salt water , but did not have corrosion as they had been painted with Graphite based antifouling paint and the boat was a trailerd boat.
Just prior to removing these drives I completely stripped these to bare metal, primed with Dupont Epoxy and refinished in White polyurethane. The upper bearings were replaced, both drives were resealed on the top with new u-joints installed on the CV joint assemblies.
Transom plates
Aluminum bellhousings to fit Chevy engines
Intermediate housings, (I have the bearings to rebuild these and can sell as rebuilt for additional $)
Also available are several tilt motors , I believe I have 4 or 5 of these.
Pictures here:
http://www.donzi.net/forums/attachment.php?attachmentid=51118&d=1254064306
All components available in any way that some one desires. Need the space!
I only replaced these as I found a set of 280 drives with power trim.
I am able to ship and accept credit cards, Pay Pal is preferred.
Please contact me directly via email!!! Mario@VSR1.com
or call at 603-228-2888
Mario L.