View Full Version : options in prop selection volvo 250
thescooter
08-11-2011, 06:47 PM
what is the prop selection for my 28' bertram baron with twin volvo 250 short shafts 1.35 gears?
new 302 motors are turning aprox 5400 rpm's with aluminum 15x17 Left and Right props.
Stainless, Aluminum, Nibral.
New used etc.
any info suggestions would be great.
nick the scooter
mrfixxall
08-11-2011, 07:29 PM
what is the prop selection for my 28' bertram baron with twin volvo 250 short shafts 1.35 gears?
new 302 motors are turning aprox 5400 rpm's with aluminum 15x17 Left and Right props.
Stainless, Aluminum, Nibral.
New used etc.
any info suggestions would be great.
nick the scooter
here is your only option..http://www.solas.com/newweb/propeller/search/volvo.asp?cat=E&SKindNo=S07&Skind=VOLVO PENTA AQUAMATIC SP STERN DRIVE
look to the left colum and pick volvo penta aquamatic..
thescooter
08-11-2011, 08:09 PM
is there away to put a long shaft prop on a short shaft drive?
mattyboy
08-11-2011, 11:00 PM
is there away to put a long shaft prop on a short shaft drive?
yes several ways
mrfixxall
08-11-2011, 11:13 PM
is there away to put a long shaft prop on a short shaft drive?
you will need 2 of thease,,install the cone and drill and tap the prop shaft..done a few,just go slow while drilling the shaft..
http://cgi.ebay.com/ebaymotors/VOLVO-PENTA-Prop-Cone-354045-354045-2-NEW-_W0QQcmdZViewItemQQhashZitem35b37d340dQQitemZ23064 4593677QQptZBoatQ5fPartsQ5fAccessoriesQ5fGear
mattyboy
08-12-2011, 10:29 AM
Drilling and tapping is one method
machining a threaded washer and using a backing nut is another way
changing the prop shafts is also available but PITA$$$$$$$$$$
no matter what method you use you are going to need an assortment of thrust washers in various lengths.
depending on the prop and if there is any offset or no offset in the hub you will have issues with the prop hitting( bottoming out on ) the anode by the prop shaft or being to far from that anode and not having enough meat to fasten the prop on the end of the shaft or hitting the torque tab if you have them.
with the threaded washer/ backing nut setup and various length thrust washers, I have run any long shaft prop on a short shaft 250 . I have also run all my short shaft props on a long shaft 270 .
thescooter
08-12-2011, 08:47 PM
has anyone used ron hill for volvo 250 short shaft props?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.