View Full Version : installing bennett m80 trim tabs on sweet 16
cb taylor
05-15-2011, 03:33 PM
has anyone installed the m80 bennett trim tabs on sweet sixteen with the upside down fins? Any problems?
has anyone installed the m80 bennett trim tabs on sweet sixteen with the upside down fins? Any problems?
The fins belong down!
Mooglide93
05-16-2011, 01:26 PM
Just converted from Trim Master to Bennett on my '22 Classic..... great products and absolutely above and beyond customer service!!!! Call Bennett Tech Support , they are the best!!!!!:)
Just don't mount them as per the Bennet instructions, they mount them flush with the hull bottom that can scrub speed. There are several good posts on mounting them for best performance.
Phil
Tabman
05-17-2011, 10:31 AM
Just don't mount them as per the Bennet instructions, they mount them flush with the hull bottom that can scrub speed. There are several good posts on mounting them for best performance.
Phil
CB,
I think that the M80s would be a great choice for your Sweet16, but of course I am a little biased.
As far as mounting them so that they clear the waterflow and don't scrub off any speed when reacted, the M80s mount 1/4" above the hull bottom at the transom and 5/8" above the bottom at the trailing edge.
http://i110.photobucket.com/albums/n109/tlmcgow/120neg.jpg
This allows the Trim Tab to ride above the water when fully retracted and should bot take anything off your top end.
Tom McGow
Bennett Marine
John C in PA
05-17-2011, 10:51 AM
Thx Tom. With all the rain in PA I'll probably install my ST9's this week and this info will help.
John C in PA
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.