PDA

View Full Version : 1972 18 Classic "unfinished project"



2donzi2
03-04-2011, 07:36 PM
72 classic 18. No time to finish. Everything to this point done on the boat has been done right. No short cuts taken. Deck removed and new aluminum fuel tank installed. Stringers, gussets and transom are solid. Deck coring is solid. Stripped deck down, repaired all stress cracks grinding and filling with glass and gel, no body fillers. Deck completely blocked out and re gel coated in white, wet sanded and buffed. Hull was stripped to original gel (orange), any necessary repairs made, sprayed with high build epoxy primer, blocked out and is ready to shoot color. All the chrome has been re plated and ready to install. I will include the Volvo 280 outdrive with the purchase. Outdrive is in good shape. Just needs light sand and resprayed. Also, bell housing and additional parts I have will go with boat. I do have a motor, but am selling the motor seperate. Boat sits on a single axel aluminum trailer which can use a little attention, but is workable. Also have a complete set of new stewart warner guages that go with the boat, wire harness, and shift/throttle cables. Have two new roto cast bucket shells for front seats. Boat basically needs color on hull, motor installed and interior. This boat is rock solid. This is an easy project for someone. All the nasty, messy stuff has been done, and done right at that. Have way more in it. Just need to make space and do not have time to finish it. You can see more pictures in the thread, My 72 Project. This boat is a left hand drive which is really cool. $4500.00http://www.donzi.net/forums/showthread.php?t=62914&highlight=72+project

cmickey55
03-05-2011, 12:25 AM
What kind of motor do you have?
jamiller1946@gmail.com
1 716 652 4139

2donzi2
03-05-2011, 01:27 AM
400cid small block chevy, built by a reputable machine shop in Daytona Beach. It does have the aluminum corvette valve covers which came with the original motor (350 chris craft) which are not installed.

Sweet little 16
03-31-2011, 09:53 AM
still for sale?

2donzi2
03-31-2011, 01:39 PM
still for sale?

haven't really tried to sell it other than list it here. This boat is a great project. Just needs color on the hull and rigged. All the chrome is done, new instruments and deck has been re gel coated. Take 4500.00 for the hull, hardware, outdrive, instruments and wire harness and misc parts and trailer. Excludes the 400 sbc that I built for it. Thanks for the interest.

drm101
03-31-2011, 06:51 PM
Where are you located? You may also want to post pics of the parts you are including with the boat.

Buddyc
03-31-2011, 08:03 PM
I sent you a pm about the motor
Thanks

Dan S
04-08-2011, 09:04 AM
Hi,

What state if the boat located in?

Regards,

Dan
89 Formula

2donzi2
08-18-2011, 06:26 AM
thanks tom and as you saw you got a beautiful boat with lots of stuff