View Full Version : CMI Headers
BlakeSullivan
11-03-2010, 03:33 PM
I bought these headers new 2 weeks ago for a 500 efi to put on my 22 Donzi and the hatch will not shut so I have order a custom set from cmi and have to sell these. They have been bolted on and the motor has been run on the hose for all of 5 minutes. 3k Shipped. Thanks Blake Sullivan 832-526-7295
Conquistador_del_mar
11-04-2010, 12:28 AM
Blake,
Do yours have the "cool tubes" at the mounting flange? Are you selling them with the input cooling hose assembly? Just curious, Bill
mrfixxall
11-04-2010, 12:50 PM
I bought these headers new 2 weeks ago for a 500 efi to put on my 22 Donzi and the hatch will not shut so I have order a custom set from cmi and have to sell these. They have been bolted on and the motor has been run on the hose for all of 5 minutes. 3k Shipped. Thanks Blake Sullivan 832-526-7295
etops wont fit ,,sport tubes will, they need to custom make the tails..
BlakeSullivan
11-04-2010, 06:36 PM
They come with the cooling tubes but I bolted them to my silent choice so they do not come with and mounts to go to the transom. As for the E top headers they will not fit because my boat is the blackhawk and I have next to no clearance stock. Thanks
blackboat
11-05-2010, 02:38 PM
Do you know the height from a bolt hole to the very highest point of header ?
BlakeSullivan
11-05-2010, 07:25 PM
I will have to get the measurement tomorrow morning thank Blake
BlakeSullivan
11-07-2010, 06:37 PM
The headers are from the front bolt bottom to the very top just over 17 inches at the highest point. Thanks
BlakeSullivan
11-23-2010, 10:05 AM
Bump 2800 shipped
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.