Conquistador_del_mar
05-15-2010, 10:50 AM
I found time yesterday to check out this tilt motor that I had as a backup. It works perfectly, but I do not have the plastic cover for it. Even if you don't have a plastic cover, you could find something to drill a hole into and screw into the threaded hole at the top. This one has the Electrolux motor as shown. On the two solenoids, the open upper spade connector is the one that needs a positive to drive the stainless shaft down. On the other solenoid, there is one open at the bottom which needs positive to bring the shaft back up. I ran it up and down a few times and cleaned and greased the shaft which is straight and still has the stainless base plate. It has the mounting gasket, plastic sleeve, and o-ring. I will mark the connectors for installation. I have seen these go for over $250 on ebay, but I would sell this one for $160 which includes shipping to anywhere in the continental US to someone here. My best contact is Dgill25960@aol.com or call me at 903/786-6281.