David Hartmann
04-15-2010, 05:02 PM
I have a Volvo 250 set up that was taken out of a boat a few years ago due to a cracked engine block.
Drive, Transom assembly, bell housing for a ford engine. and the tilt assembly.
This is a ford bell housing that is a low profile version which allow for a windsor motor to fit in a 16' without cutting into the seat. This was really hard to find and is quite valuable to a Donzi / volvo / ford fan. It could easily be swapped out for a GM version.
2 props
stainless 21"
al 23"
Drive had the performance tip added to the bullet
I am looking to get rid of everything quick. I am posting it here first. The first reasonable offer gets it.
Dave
860 944 1210
davidh@hornetmarine.com
Drive, Transom assembly, bell housing for a ford engine. and the tilt assembly.
This is a ford bell housing that is a low profile version which allow for a windsor motor to fit in a 16' without cutting into the seat. This was really hard to find and is quite valuable to a Donzi / volvo / ford fan. It could easily be swapped out for a GM version.
2 props
stainless 21"
al 23"
Drive had the performance tip added to the bullet
I am looking to get rid of everything quick. I am posting it here first. The first reasonable offer gets it.
Dave
860 944 1210
davidh@hornetmarine.com