craigw027
03-16-2010, 02:02 PM
I am looking for a wiring harness for a Thunderbolt 5 Ignition. I only require the plugs, easy enough to cut off if possible, but more than willing to take the whole thing. The ignition control module is an 8 pin and the knock control module is a 5 pin. The same set-up as shown in the diagram on page 7 and 8 of the following website. http://www.boatfix.com/merc/Techbk/95/95HGB4.PDF (http://www.boatfix.com/merc/Techbk/95/95HGB4.PDF)
Get back to me if you can help me out.
Thanks,
Craig Wilson
craigw027@yahoo.ca
Get back to me if you can help me out.
Thanks,
Craig Wilson
craigw027@yahoo.ca