Hydromotive 3 blade Sport Cleaver

[Walt. H.]

Hydromotive Sport Cleaver:
Looks like brand new, no nicks not even a sand scratch.
R/H 15-1/2"dia, X 24" pitch 15-spline for all Mercruiser stern drives and big Merc & Yamaha O/board eng.
$295.00 plus $15.00 for U.P.S shipping, i'll pay the additional cost above $15.00 which there will be some.

[rchevelle71]

Nice prop, if it were a lower pitch, I'd be buying it, but cant spin this one.

[Walt. H.]

T.t.t

[flying tomato]

Do you still have the prop?

[Greg Guimond]

Will it fit a Merc small shaft ?

[Walt. H.]

Do you still have the prop?

Will it fit a Merc small shaft ?
Yes I do..

Greg,
As noted above it has a 15 spline 1-inch dia shaft hub for all Mercruiser stern drives and large gear case Merc & Yamaha o/b engines, if you're asking about fitting a small gear case merc o/board i'd have to say no because the hub also known as the can diameter will be to large.
The can is the part that the blades are attached to.
WH.

[Walt. H.]

Do you still have the prop?
Still available

[CaribouLou]

Can this be hubed for an OMC drive?

[Walt. H.]

Yes at a prop repairshop, by pressing out the existing hub and installing a new OMC hub assembly.

[Walt. H.]

bump!

[Tborisch]

What did you run it on?

Tom

[Walt. H.]

What did you run it on?
Tom
Tom,
I've have it in my collection for almost three yr's now, its not enough pitch for one of my boats and too much for the other thats why its forsale.

What are the specs of your current prop and what is your max rpm with a 1/4 to 1/2 a tank of fuel when you're alone in the boat.

Also you could make a inquiry here for some possible input from other members that have experience with your model boat if this prop might be what you may want, there are so many variable in the pursuit of that near perfect prop and is the major reason we buy to try another propeller hoping to maybe tweak a little more performance like our women buy shoes.:wink:
Wal

[Walt. H.]

Bump and i'll pay the shipping within the U.S., outside will be extra.

[upnorth]

I will buy it if it still available. E-mail me peter.winik.ff@gmail.com

[Walt. H.]

I will buy it if it still available. E-mail me peter.winik.ff@gmail.com
Yes it is still available and sorry that its taken almost a week to answer you, I haven't had much time for the computer the last ten or more days.
If you're still interested in buying it let me know where your general mailing address would be so I can check with U.P.S on what the extra shipping would cost me, since I see your are located in Canada and that will cost me abit more then within the U.S boarders but if its within reason i'll swing it.:yes:
E-mail sent but it bounced back undeliverable after a few minutes, I tried sending it again and it didn't return so hopefully it went through but figured to reply here knowing for sure that you'll be informed.

[Walt. H.]

I will buy it if it still available. E-mail me peter.winik.ff@gmail.com
I guess not? I'm figuring he doesn't want it now, so its currently out of the box as of last night and back up forsale on the display wall with the others.