PDA

View Full Version : Donzi performance engine parts



clearpaths@comcast.net
12-22-2009, 12:28 AM
Cleaned out garage and have many left over parts from past sweet 16 and 18 2+3 boats I have had in the past. Get your donzi a holiday gift... Can ship to 48 states your dime call or email. 561.795.3062, clearpaths@comcast.net.

Stainless Marine wet exhaust. Run 3 hours on dyno engine. $1050 see attached photo.

327 corvette fuelie motor. Long block. Zero time perfomance build. Fully machined and balanced. Lots of goodies in this great engine. Dyno'd at 385 HP. 3 hours run time. $2500 More pics and info available.

Nicson marine timing cover for cam driven water pump set up. 3 hours run time. $120

Custom Crank and alternator pulleys made from 600 series nickel, will never rust. $150

Rebuilt chevy SBC starter for 153 tooth flywheel, Fully marinized rebuild by local starter / altenator shop. 3 hours use. $ 60

Rebuilt chevy altenator with bronze mount bracket, fully marinized rebuild by same shop as above. 3 hours run time $60

Gil marine thermostat housing for wet exhaust set up. 3 hours run time. $55

GM 153 tooth flywheel for SBC to vovlo 280 setup. GM P/N 3791021. In excellent used condition. Also fits 60-70's camaro Z-28, chevelle, corvette. $ 120

Carter mechanical Fuel pump for SBC, marinized, 3 hour run time. $35

67-68 DZ302 camaro Z-28 intake, low miles, light restoration, excellent condition. GM P/N 3917610. $450

See attached photos, many more pics available. Will answer any questions and give more details if requested. Thanks

1234rob
12-28-2009, 09:10 PM
i have a 1966 16' donzi. i have had 4 ford motors blowup and would like to try a GM but i am on a buget!! so if you can give a little on all your parts i would like your 327 i think it would be a good fit. (for my boat) i think that my boat is the oldess 66 in the world i have the 17th boat in 1966. if there is a older boat in 66 i hop to find it??some day??just to see it.

clearpaths@comcast.net
12-28-2009, 10:55 PM
1234rob - I am flexible on prices and will entertain any reasonable and intelligent offers. Please email or call me at info in my post. I am off work thru friday.

1234rob
01-04-2010, 04:18 PM
hi how much for all the motor parts $

clearpaths@comcast.net
01-08-2010, 11:39 PM
1234rob - Please email, call or PM to discuss what all the parts you are after. Look forward to speaking with you. Thx

clearpaths@comcast.net
01-08-2010, 11:47 PM
1234rob - Please email, call or PM to discuss what all the parts you are after. Look forward to speaking with you. Thx

PM'd you 1234rob