View Full Version : 454 Exhaust Risers/manifolds
Fast Shafts
10-27-2009, 01:36 PM
Looking to replace the exhaust manifolds on my cruiser. Looking for "like new" take offs. The engine is a 2001 454 MPI Merc. Anyone upgrading their engine with new exhaust, and want to get rid of old?
Bob 732 864- 9724
fogducker III
10-27-2009, 02:26 PM
Looking to replace the exhaust manifolds on my cruiser. Looking for "like new" take offs. The engine is a 2001 454 MPI Merc. Anyone upgrading their engine with new exhaust, and want to get rid of old?
Bob 732 864- 9724
Hi Bob, I have these, was planning on using them for a project but plans changed. VERY light fresh water use, shipping might be the kicker, where are you located? Jeremy.
http://www.usedvictoria.com/classified-ad/10237499
CJmike
10-27-2009, 02:54 PM
I have a set off a 454 mag setting in the attic. Fresh water as far as I know.
Tidbart
10-27-2009, 05:29 PM
Just a thought, look at GLM Aluminum manifolds. Lose a lot of weight, and there bolt on.
Bob
Choprpilot
10-28-2009, 08:58 PM
Also have a set of take-offs fresh water use only. Note: Risers are cast SS. $300.00 US takes them.
Again shipping probably would be expense.. In case your interested contact: choprpilot1@aol.com
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.