Need Strainer Lid Glass

[ScottL]

I recently purchased a 35 ZR with 525's. I tried to clean the lids in the sea strainers and they need new glass inserts.

I looked as much as possible to try and find the manufacturer on-line as there is nothing on the strainer itself. The only thing I found is the Lavorsi SS series that has the same look on the top with the wing nuts, but mine are approx. 10" deep.

Any help will be appreciated.

[CHACHI]

Check on Teauge Marine's site. You will find that the two units were seperated at birth.

Ken

[Air 22]

I recently purchased a 35 ZR with 525's. I tried to clean the lids in the sea strainers and they need new glass inserts.

I looked as much as possible to try and find the manufacturer on-line as there is nothing on the strainer itself. The only thing I found is the Lavorsi SS series that has the same look on the top with the wing nuts, but mine are approx. 10" deep.

Any help will be appreciated.


I think those are a plexi-glass insert...U might be able to get then cut locally using your originals as templates.??. just an idea...:)