trim tabs

[zedohsix]

Have a sweet 16, trim trab's are mounted to low, what would be my best selection for new tabs or relocation of old ones. thanks :canada:

[VetteLT193]

what does too low mean?

there is a post here that changes the rams internally so the tabs come up more, so instead of the up position being even with the bottom they are actually above horizontal.

It's supposed to be easy but I haven't done it yet.

[BigGrizzly]

First show a picture. If they are Bennetts there is an easy fix

[zedohsix]

sorry I was not clear, the tab switches are located to low and it is very difficult to use while holding the wheel and throttle

[VetteLT193]

well that paints a different picture.

You might consider using a wheel mounted remote switch setup. Then you don't have to mess with more holes in the boat and they will be at your fingertips.

[VetteLT193]

check this out, I found the wheel mounted one along with a foot mounted one... page 8

http://www.cpperformance.com/SearchResult.aspx?CategoryID=28

[zedohsix]

bump

[Carl C]

Vette's reply looks like a good one to me:confused:.