fogducker III
11-08-2008, 10:29 AM
Can somebody tell me if the inside transom/gimbal plate for an Alpha drive unit be used for a Bravo set-up? I realize everything outside of the transom has to be Bravo but from what I can see, holes line up and plates are same size? Steering ram and lines appear the same as well?
I have a project and would like to avoid removing the engine to swap out the inside plate. It is a complete Alpha unit which is getting tired and I would like to replace it with a Bravo set-up, which leads me to the second part of my question.... will a Bravo unit with 1:36 gears be a suitable unit for a heavier 21' boat with a 383.............? Thanks for any input.
I have a project and would like to avoid removing the engine to swap out the inside plate. It is a complete Alpha unit which is getting tired and I would like to replace it with a Bravo set-up, which leads me to the second part of my question.... will a Bravo unit with 1:36 gears be a suitable unit for a heavier 21' boat with a 383.............? Thanks for any input.