Part numbers for valve springs and 1:6's Jim ?

[Lenny]

Jim, do you have the part numbers for a set of springs for the small block and also a set of 1:6's.

Might as well put those on while it is apart. (as you suggested)

'87 350 MAG

[BUIZILLA]

somewhere I do... :wrench: :rolleyes:

[MOP]

Lenny do you have Vortec or non heads? I have a set of 1.6's for non Vortec that I will let got cheap.

[Lenny]

I beleiev they are Vortec. The Stainless Marines I have have the 4 bolt set-up as do the heads.

[MOP]

You need to make sure the rockers arms are quite different between the two head styles.

[BUIZILLA]

Pro Magnum rockers
1.6 self aligning #1318-16
1.6 non self aligning #1302-16

beehive stock upgrades #26981
stock upgrades #981

COMP cam products

don't forget to check the pushrod holes for interference :nilly:

and those pesky valve seals... :rolleyes:

and then there's the double thickness silicone cover gaskets...

that should do it... :party:

too bad the valve spring tools are in my toolbox :eek:

which is about 6 jillion miles from you :kingme:

[Lenny]

beehive stock upgrades #26981
stock upgrades #981
COMP cam products

I take it these are the springs?

[BUIZILLA]

10-4