View Full Version : Part numbers for valve springs and 1:6's Jim ?
Lenny
10-07-2008, 08:04 AM
Jim, do you have the part numbers for a set of springs for the small block and also a set of 1:6's.
Might as well put those on while it is apart. (as you suggested)
'87 350 MAG
BUIZILLA
10-07-2008, 08:38 AM
somewhere I do... :wrench: :rolleyes:
Lenny do you have Vortec or non heads? I have a set of 1.6's for non Vortec that I will let got cheap.
Lenny
10-07-2008, 02:24 PM
I beleiev they are Vortec. The Stainless Marines I have have the 4 bolt set-up as do the heads.
You need to make sure the rockers arms are quite different between the two head styles.
BUIZILLA
10-07-2008, 03:24 PM
Pro Magnum rockers
1.6 self aligning #1318-16
1.6 non self aligning #1302-16
beehive stock upgrades #26981
stock upgrades #981
COMP cam products
don't forget to check the pushrod holes for interference :nilly:
and those pesky valve seals... :rolleyes:
and then there's the double thickness silicone cover gaskets...
that should do it... :party:
too bad the valve spring tools are in my toolbox :eek:
which is about 6 jillion miles from you :kingme:
Lenny
10-07-2008, 04:49 PM
beehive stock upgrades #26981
stock upgrades #981
COMP cam products
I take it these are the springs?
BUIZILLA
10-07-2008, 06:21 PM
10-4
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.