PDA

View Full Version : VOLVO 250 TILT MOTOR PIN ++ Wiring



KDG
06-23-2008, 11:59 AM
Good Aftrenoon:

Would anyone know where to obtain the pin that goes through the shaft for the tilt motor with a Volvo 250 outdrive? I am also looking to find out how to wire the motor as well. The drive transom housing was received "off of the boat" and I have no way on knowing how to to wire it for operation. Any assistance would be much appreciated.

Thanks,

Kurt

MOP
06-23-2008, 12:10 PM
The pin that goes in the end of the shaft is a pretty standard "roll pin" some auto parts stock them, the wiring was done in a couple of flavors, I gave my last Volvo manual to Wayne the SUB driver. Try PMing him for a copy of the wiring diagrams.

This site has a decent stock of parts, plus if it is not listed email them they have a lot not listed.
http://www.hlsm.com/

Phil

KDG
06-24-2008, 11:42 AM
Phil,

Thanks for the reply. I looked for Wayne, Subdriver, etc. under the member list to find his e-mail but no luck. Would you have an e-mail for him?

Thanks,

Kurt

penbroke
06-24-2008, 12:11 PM
Try onesubdrvr here. In the meantime maybe this will help.

Frank :alligator

KDG
06-25-2008, 02:31 PM
Thanks for the diagram