PDA

View Full Version : New kind of switchable exhaust?


VetteLT193
05-23-2008, 12:16 PM
Anyone seen these yet?

http://cgi.ebay.com/ebaymotors/Seatech-el-switchable-Exhaust-Diverter-Mercruiser-SB_W0QQcmdZViewItemQQcategoryZ31285QQihZ024QQitemZ 370051642997QQrdZ1QQsspagenameZWDVW

Price is much cheaper than Corsa.
gcarter
05-23-2008, 12:48 PM
I've seen these advertised for at least a year and yes, they are very reasonable. Never seen any installed.
VetteLT193
05-28-2008, 03:15 PM
no one else knows anything? the price is really tempting me
mrfixxall
05-28-2008, 03:34 PM
no one else knows anything? the price is really tempting me

yeppers,good stuff!! their made in germany and the nice thing about then is the motors are gear driven,like a power antenna,, and are adjustable from quiet to kinda loud to loud..no constant power on or off just use a momentary switch to adjust the tone:)
VetteLT193
05-28-2008, 05:11 PM
Thanks man!

On a donzi with through hull, what else is needed besides the Y assembly?
kd5cue
05-28-2008, 05:29 PM
ill stay with my hardin marine air acated ones
The Hedgehog
05-28-2008, 06:38 PM
Thanks man!
On a donzi with through hull, what else is needed besides the Y assembly?

I dunno but I have a Y-pipe laying around. I can't think of anything else. Maybe some connecting hose?
BUIZILLA
05-28-2008, 07:12 PM
I like it...
mrfixxall
05-28-2008, 09:03 PM
Thanks man!
On a donzi with through hull, what else is needed besides the Y assembly?

Tips,4'' hose,band style clamps,screws for the tips and sealer :)

O one more thing you have to yank the motor..
VetteLT193
05-29-2008, 10:45 AM
Tips,4'' hose,band style clamps,screws for the tips and sealer :)
O one more thing you have to yank the motor..

I already have tips, it's through hull stock... I need the 'standard' components to route the exhaust through hub. I know I don't have a Y pipe in there. I just don't know what exactly I need to get the Y pipe installed.

Why would I have to pull the engine?
The Hedgehog
05-29-2008, 11:18 AM
I already have tips, it's through hull stock... I need the 'standard' components to route the exhaust through hub. I know I don't have a Y pipe in there. I just don't know what exactly I need to get the Y pipe installed.
Why would I have to pull the engine?

Fix is right. Go take a look down there and see if you can figure out a way to take off the block off place and bolt up a Y-pipe without pulling the engine.

You also need to make sure it it bolted up properly. A leaking Y-pipe can sink your boat.
kd5cue
05-29-2008, 02:32 PM
it be easier install y pipe if motor was pulled,,,you need real small hands
VetteLT193
05-29-2008, 04:53 PM
ok.. good enough explanation for me:)