wiring, rigging, uhmm

[tiger lily]

anyone know how to wire these in, or where i could find a schematic for it ? need to build some wiring harness, for 454's, or is there a place to buy them?

[mrfixxall]

anyone know how to wire these in, or where i could find a schematic for it ? need to build some wiring harness, for 454's, or is there a place to buy them?


Try here:wink:

http://www.msdignition.com/1download.htm

[tiger lily]

thanks, just found that , itll work, ive got quite the project in front of me, lots to learn, lots of questions to ask.. after wiring, comes alternators, fuel, steering,trim, oh my....

[Ed Donnelly]

What are you running, turbos or superchargers?...Ed

[tiger lily]

What are you running, turbos or superchargers?...Ed

superchargers

[tiger lily]

....

[mrfixxall]

....


Tight Squeezzzzzzzzzze! R U running solid mounts?

[tiger lily]

Tight Squeezzzzzzzzzze! R U running solid mounts?

yeah, aluminum bolted through

[tiger lily]

Err, when did your 18 Classic get twins??:eek!::nilly::eek!::boggled:


hehe, i still have the tiger lily, ill always have that boat, its sitting right next to this one, this one just seemed to follow us home last week? its wierd out that works

[mrfixxall]

yeah, aluminum bolted through

whos disttributors rou using? mallory of msd?

[justleft]

You can get all of the weather tight electrical connectors at Jegs or Summit.
Then you don't have splice on to the short leads.

[Ed Donnelly]

Don't forget the J tubes on the carbs

Big carbs REALLY BIG superchargers..........Ed

[tiger lily]

whos disttributors rou using? mallory of msd?

mallory

[mrfixxall]

mallory


unilite?

[tiger lily]

unilite?

i wish i could tell ya, theres alot to this boat that i dont know, bought it with, "some assembly required"

[mrfixxall]

i wish i could tell ya, theres alot to this boat that i dont know, bought it with, "some assembly required"

ok just to give you some more info,,if theirs three wires coming out of the dist green is the trigger, black is ground and red is the power( you need to run 2 resistors on the red wire or you will burn our the electric eye... Max 8 volts to the wire,measure after you supply 12 v to resistors after about 5 minutes or so)

Also if your running the retard boxs you have to lock the Centrifugal advance to 0 of so it dont move..hope this helps..

[zimm17]

unilite?

Mallory Unilite = getting towed home. Keep an extra unilite module in the toolbox... they burn out. I had one in my '71 Olds cutlass and after breaking down a few times, I went MSD.

MSD has a diagnostic service- you can send in the whole mess and they'll test it out for you for a small price. I did that with a shady looking MSD box that came with my used blower. It tested good and they sent it right back.

[mrfixxall]

unilite module in the toolbox... they burn out. I had one in my '71 Olds cutlass and after breaking down a few times, I went MSD.

Yeppers, ran into thet problem myself then read the instructions:bonk: Two resisters and 13 years later i still have the same dist in my 72 monte carlo..