View Full Version : 1987 Minx LE
ECU Pirate
08-27-2007, 09:35 AM
I just picked up a 1987 Minx LE #18 of 25, 281 hrs all original. Nice clean Donzi. I have been reading up on your forums for the last few weeks. Hope to learn from the wealth of Donzi knowledge. Hope to post some photos later today.
gcarter
08-27-2007, 11:50 AM
It would be good to have a hull #.
See http://www.donzi.net/forums/showthread.php?t=39260&highlight=minx+hull+numbers
As you can see, I have many of the LEs listed, but not by series #.
By the way, welcome. The Minx is a vastly underrated boat.
ECU Pirate
08-27-2007, 02:41 PM
George,
Thanks for the welcome. I tried to register the hull #, but the registry is down for updating.
gcarter
08-27-2007, 03:32 PM
Post it here and I'll get it on the Minx list.
ECU Pirate
08-27-2007, 04:12 PM
Hull # DMRCB 128C787
You'll love that boat. I know I did.:(
gcarter
08-27-2007, 06:40 PM
You'll love that boat. I know I did.:(
Joe...did you notice your #'s are sequential???
Joe...did you notice your #'s are sequential???
No I didn't. My computer crashed this weekend, and they were unable to retrieve a bit of data from my hard drive. I was wondering if it was close to mine.
ECU Pirate
08-28-2007, 08:21 AM
I want to get new cockpit carpet. Do either of you guys have any recommendations or where to get it? I have been rubbing and buffing to remove some oxidation (the only negative to the boat). It is too hot and humid in NC. Detailing was not this much work when I was a teenager.
handfulz28
08-28-2007, 09:36 AM
Where are those pictures? :propeller:
I want to get new cockpit carpet. Do either of you guys have any recommendations or where to get it? I have been rubbing and buffing to remove some oxidation (the only negative to the boat). It is too hot and humid in NC. Detailing was not this much work when I was a teenager.
I had one custom made from Sunbrella. It cost right around $300 as I recall.
ECU Pirate
08-28-2007, 07:00 PM
Thanks Cuda. Did you make a template ?
Thanks Cuda. Did you make a template ?
No, I just dropped it off at Florida Boat Tops in St Pete. They made a full cover and a cockpit cover at the same time.
gcarter
08-28-2007, 08:05 PM
Uh guys, I think he asked about "CARPET"...not "COVER"...
Try Biltrite, Bob makes great carpets for Minxs, with or without the cooler cutout.
Don't have a #.
Uh guys, I think he asked about "CARPET"...not "COVER"...
Try Biltrite, Bob makes great carpets for Minxs, with or without the cooler cutout.
Don't have a #.
My bad. Speed reading again. :(
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.