PDA

View Full Version : You think you got problems?????



Schnoogie
08-01-2007, 04:31 PM
P/U a 1968 16' ski sporter (sweet 16 some may say) It's all original supposedly sat in a garage for 23 years.
The guy said it had a spun main (289 H&M all there :yes:)
Funny noise's were the lack of bearing's in the primary shaft housing :(.
HELP!!!!!!!!! been searching the internet and can't find much.
What Im looking for is the main drive shaft, assocciated bearings and seals,etc. I'm hoping that the primary shaft housing is still good.
I really want to maintain the glory of the H&M package 289 w/Volvo 280.
Everything else is in great original shape.
I think he went for a ride with a hole in the bellows and than let it sit, who knows. Any advice will be appreceated

mrfixxall
08-01-2007, 05:33 PM
your best bet would be e bay and get rhe whole housing because if the bearings seized they seize in the housing and spin..

vonkamp
08-01-2007, 05:34 PM
I got part #s for the bearing & the bushing that goes in the crank. When I get home I will post them but it will be late. You can get the bearing and bushing from Volvo dlr. Same with shaft but you will be getting the shaft $$ wise. Check eBay, they show up regularly, do a search for "volvo penta".

BigGrizzly
08-01-2007, 05:42 PM
Frank will, get the bearing it is a common bearing. the center housing do you mean the one from the out drive to the engine, the one I have in my boay has a HM stamp on it and I have seen them repaired before.

Schnoogie
08-01-2007, 06:41 PM
I have the extension housing too stamped HM.
I didn't take it all apart yet but looking at the parts list and diagrams it seems that this shaft is supported at both ends of the Volvo "Primary Shaft housing" part# 897668.
The inner bearing (closest to the engine Volvo Part# 181105, H&M Part #C5HM1A017MB1) has a different number than the one closest to the drive, Valvo part # 19258, H&M part# C5HM7B017MB1
There are seal rings outboard of each bearing too.
Does anyone have the cross over for these so I can go to a bearing house?
That would get me started.
I do have all the original docs.

Schnoogie
08-01-2007, 06:45 PM
Griz, whos Frank?:eek!:

BigGrizzly
08-01-2007, 06:50 PM
just kidding I always look at vonkamp'.s signature and think frank zappa

Schnoogie
08-01-2007, 06:55 PM
Frank was a great man, Now back to me getting the boat back together and wet. I need some fun, the ole 34' Searay Sedan didn't make the water this year because we were going to sell it, two 454 crusaders, yeh right.
Hey the tanks are full wanna buy it?:bonk:

vonkamp
08-01-2007, 11:00 PM
Bearing- Federal Mogul 206-FF
Seal- Federal Mogul 471192

I don't have the H/M extention housing. The part #'s above are for the B/W housing