PDA

View Full Version : sx-c2 drive leg



makito
07-07-2007, 12:10 AM
Hi maybe the wrong place for this question but here goes i have a 1988 21' ragazza trying to install the sx drive leg had it in once and it just fell in then took it out 5 minutes later to change a seal and it was a little difficult to remove seemed kind of stuck but got it out changed the seal and now it will not go back in cant quite get it on far enough to start the nuts any ideas?

MOP
07-07-2007, 07:53 AM
The splines are probably hitting, I use a long screw driver through the yoke. I keep light to medium pressure on the drive and slowly twist the yoke, it should pop in.

Phil

makito
07-07-2007, 02:50 PM
Thanks Mop the splines were lining up but I just needed to give it a few gentle taps with a big block of wood to nudge it in that last inch