Team Jefe
01-08-2007, 08:47 AM
Priced to move: $44,500 obo Contact: Jeff - 713 825 2443 or teamjefe@houston.rr.com
I have loved owning this boat and enjoyed every minute of being at the helm. However, it is time to take the next step forward.
30ZF Center Console Cuddy
Donzi Performance Twin Stepped Hull
Cruise at 40-45 knots, Max Speed 55 knots
Rock solid ride, Does not “slam” off of waves & No Stepped Hull Slip in Turns
Bolstered Leaning Post, (Optional Upgrade)
Cuddy Sun pad, (Optional Upgrade)
New 5’ X 7’ T-Top installed May-06 w/ mesh life-jacket storage
Electronics
Furuno: FCV600L Color fish finder/bottom machine
Si-Tex Neptune Mapping GPS
25 Watt Marine Radio
Stereo CD/MP3 Player w/ 4 speakers
Storage for 36 Rods:
10 rocket launchers plus 2 SKA side-launchers on T-top
4 rocket launchers on Leaning post
6 gunwale & 2 transom rod holders
8 under gunwale rod holders
4 cabin rod holders
Leaning post:
35 gallon lighted live well (750 GPH)
25 gallon fresh water shower (750 GPH) and sink
Raw water wash-down (1250 GPH).
V-Berth Cuddy w/ port-a-potti and storage compartments, new cushion upholstery in 2005
Auto/Manual bilge pump (1250 GPH)
Fore and Aft in-deck fish boxes – rear box w/ macerator pump
Forward Console seat with built in cooler
Fore and Aft Coaming pads
Dual ram trim tabs & indicators
Custom built removable rear seat, easily holds four adults
Twin 2000 Model 225 HP Evinrude counter-rotating outboards
Fuel Injected with all Factory upgrades completed by OMC Certified Techs.
Starboard motor complete rebuild with approx 150 hrs since rebuild (scored a ring and lost 20 PSI compression, went with full rebuild instead of band-aid fix)
Both have new ECMs and upgraded water pumps
Both had annual service less than 10 hrs ago: new plugs, lowers done, new starter modules, new fuel/water separators
Motors have given good service and have been offshore dozens of times with NO ISSUES
Factory Upgrade done by Kroll’s Marine, Richmond TX. starboard rebuild done by Holeshot Marine, La Porte TX. All other work done by Ace’s Outboards, Seabrook TX
2001 Model Tandem Loadmaster trailer:
Spring axle Tandem rated for 12,000 lbs, spring hangers replaced 09/06
Hub/bearing rebuild and new disc brake system professionally done 09/06
Retro fitted to run 16” Load range E truck radials for more load capacity
I have loved owning this boat and enjoyed every minute of being at the helm. However, it is time to take the next step forward.
30ZF Center Console Cuddy
Donzi Performance Twin Stepped Hull
Cruise at 40-45 knots, Max Speed 55 knots
Rock solid ride, Does not “slam” off of waves & No Stepped Hull Slip in Turns
Bolstered Leaning Post, (Optional Upgrade)
Cuddy Sun pad, (Optional Upgrade)
New 5’ X 7’ T-Top installed May-06 w/ mesh life-jacket storage
Electronics
Furuno: FCV600L Color fish finder/bottom machine
Si-Tex Neptune Mapping GPS
25 Watt Marine Radio
Stereo CD/MP3 Player w/ 4 speakers
Storage for 36 Rods:
10 rocket launchers plus 2 SKA side-launchers on T-top
4 rocket launchers on Leaning post
6 gunwale & 2 transom rod holders
8 under gunwale rod holders
4 cabin rod holders
Leaning post:
35 gallon lighted live well (750 GPH)
25 gallon fresh water shower (750 GPH) and sink
Raw water wash-down (1250 GPH).
V-Berth Cuddy w/ port-a-potti and storage compartments, new cushion upholstery in 2005
Auto/Manual bilge pump (1250 GPH)
Fore and Aft in-deck fish boxes – rear box w/ macerator pump
Forward Console seat with built in cooler
Fore and Aft Coaming pads
Dual ram trim tabs & indicators
Custom built removable rear seat, easily holds four adults
Twin 2000 Model 225 HP Evinrude counter-rotating outboards
Fuel Injected with all Factory upgrades completed by OMC Certified Techs.
Starboard motor complete rebuild with approx 150 hrs since rebuild (scored a ring and lost 20 PSI compression, went with full rebuild instead of band-aid fix)
Both have new ECMs and upgraded water pumps
Both had annual service less than 10 hrs ago: new plugs, lowers done, new starter modules, new fuel/water separators
Motors have given good service and have been offshore dozens of times with NO ISSUES
Factory Upgrade done by Kroll’s Marine, Richmond TX. starboard rebuild done by Holeshot Marine, La Porte TX. All other work done by Ace’s Outboards, Seabrook TX
2001 Model Tandem Loadmaster trailer:
Spring axle Tandem rated for 12,000 lbs, spring hangers replaced 09/06
Hub/bearing rebuild and new disc brake system professionally done 09/06
Retro fitted to run 16” Load range E truck radials for more load capacity