Hinges and fastners hardware question

[cigarette8888]

Anyone know where I can locate this hardware? Some of my hinges and fastners are falling apart:smash: If you know the names or part numbers that would really help!

[gcarter]

Yep;
Try Jamie at Lakeside restorations. See advert on this site.
Not sure about hinges, but the hatch latch he can do.
But if you take the chromed bronze parts to a re-chromer, thay can build up worn pieces with copper before re-chroming. Either way be prepared to get a check out of the BIG check book.

[Marlin275]

Did you try Donzi Marine or dealers?
I got the roll-pin from Donzi.

[BERTRAM BOY]

B and C are Perko parts.

[cigarette8888]

Thanks everyone - I am investigating these ideas now. I am still looking through the Perko catalog, they have alot of equipment.. Happy Thanksgiving!

[kjly63]

Actually, B & C should say Chris Craft on the bottom. Mine do and are identical. Good luck finding them.........I had mine rechromed.

Ken

[BERTRAM BOY]

Okay, Kenny you smart @#$. I stand corrected. If they are Chris-Craft parts, check out Algonac Cast Products in Michigan.

[gcarter]

Someone correct me if I'm wrong, but the CC parts are "straight" hinges and designed to be used on a hatch hinged on the side of a deck, while the pins on the Donzi parts are "cranked" to allow for camber to allow for a forward opening hatch.
My hinges, lifting rings, and finish plates cost about $350.00 to re-chrome about 15 months ago.

[Bob]

The hinges are about $50 each from Algonac.

[cigarette8888]

I am going to try and order those hinges with Algona on Monday, thanks http://www.algonaccast.com/
Also, I found these Hood Locks that look similar to what I have. They are item number 260045778561 on ebay. Its $125 for two. They don't look like an exact match and the Bracket isn't going to work at all.... hummm
What about item A?? Any ideas?? That is actually my worst part. I have two that are cracked. Maybe Algona?? - I will ask them...

[gcarter]

Algonac doesn't offer them chromed, I've heard.