HotRodr56
06-08-2006, 04:33 PM
Been busy all winter on my Z33 installing a new cabin and upgrading mechanicals. Still not finished and now it is time to get on the water. I had the port engine out of the boat and replaced the Borg Warner trans. What procedure should I use for outdrive alignment on a TRS drive and does the standard Merc alignment tool work for this drive? I have read procedures for many other outdrives but can't find anything specific to the TRS setup. I have looked for an alignment tool that fits the TRS but again can't find anything specific for the drive. Any experienced advice would be appreciated.