PDA

View Full Version : FS: Volvo 250 drive complete and 275T complete w/trim tilt and PROPS!!



Moody Blu'
04-11-2006, 10:42 PM
I have two complete drives for sale v/8 ratio is 1.61:1

one is on my boat, a volvo 250 aquamtic there is one bolt broken off and has to be drilled out to work properly again drive is rock solid.

other is one i bought when i was thinking about swapping out my 250 for a drive with trim. this drive looks exactly like my 250 except for a few variations and it has hydraulic trim and tilt. when i bought this drive i wanted to make sure the trim worked so I stood on the drive while it was still mounted on the boat i bought it out of and they raised the trim up and down a couple times with me standing on the back to see if there were problems(I weighed about 165) so it works good. the lower unit has a slightly stripped threading and may need to be fixed, or you can just swap your lower form a 250 etc. this 275 had a 302 motor behind it so i figure the drive ratio is correct for a v8. it was also a fresh water only drive and looks pretty good besides the disgusting paint job on it. it has everything you need to add trim and tilt to your older style donzi. the hydraulic pumps and everything is there just swap it and wire it up and fill up the hydraulic fluid.


volvo 250- 800 or BEST offer?

volvo 275T 1550 or best offer?

I also have 2 bell housings for ford motors ONE IS A H&M bell housing the other is painted or powdercoated blue-very nice. not sure if i want to sell my H&M bell housing unless i can adapt it to what i been thinkin about doing.

i am not sure what the market is calling for these drives so please i wont be offended if i am to high. i am sure i will find a good price.

I also have 2 really good propellers.

i have a LH 24 1/2"x 14 1/2" brass prop which was just done last season and it is a awesome prop 375 or best offer

this prop got me up to my highest top speed and still pulls out of the water hard with my motor setup. if i didnt have bototm paint it would be even faster. fuel efficiency is very good as well.
http://i35.photobucket.com/albums/d194/beerock69/me%20pics/boat/DSCF0107.jpg


I also have a RH ultra 26px14 ??? not sure havent looked in a while 450 Or best offer

remember everything is negotiable.

i will even trade for some things if im interested.

I need audi s4 parts and possibly some hardware materials for my tank project and transom stringer reinforcement...

hope this gets some bites!!

Lenny
04-11-2006, 11:44 PM
Moody, that 26" RH Ultra has my eye. Seriously has my eye. Shoot me a pic will ya :)

highlnd@telus.net

Moody Blu'
04-12-2006, 12:03 AM
im workin on that i dotn have any pics of it so my dad has to take them if the prop is at his house otherwise its in my van.(i think its in my van not sure) lol

the propeller has minor damage on it from sitting in a shop(the inner edges are mashed a bit its a cheap fix my prop guy quoted me like 65 to fix it rebalance etc.

ill let you know about pics

MOP
04-12-2006, 06:12 AM
A note the T&T Moody is selling I helped him get, it came off a small ski boat from fresh water if I remember correctly the engine hour meter showed only 116 hours. It is not the "Elephant style" it is the unit that is built into the transom shield, it is very clean looking and compact and had -0- corrosion when MB got. He never got around to doing the project so it is in F/W condition with little use.

Phil

Moody Blu'
04-12-2006, 09:29 PM
ultra pics, compliments of my pops,(it was at my shore house)

as you can see there are very slight nicks and a weird mashed area near the start of the blade front part of the hub. supposedly this prop was on the shelf its whole life and the slight damage is from something other than boat usage? not really sure how that happened.

http://i35.photobucket.com/albums/d194/beerock69/me%20pics/boat/IMG_2093.jpg

http://i35.photobucket.com/albums/d194/beerock69/me%20pics/boat/IMG_2094.jpg

http://i35.photobucket.com/albums/d194/beerock69/me%20pics/boat/IMG_2095.jpg

http://i35.photobucket.com/albums/d194/beerock69/me%20pics/boat/IMG_2097.jpg

http://i35.photobucket.com/albums/d194/beerock69/me%20pics/boat/IMG_2098.jpg

Lenny
04-12-2006, 10:52 PM
Moody, let the 26 go to whomever. $450 and the work required and "right rotation" is too steep for me. The "right is fine" but not the work. Thanx anyways :)

Take care, Lenny

Moody Blu'
04-13-2006, 12:17 AM
well if you like i can have this prop fixed if you think it would be worth the 450 then? i mean thats why i said or best offer ;)

id rather sell here then on ebay

dubberstuff
07-08-2006, 01:38 AM
Is the LH prop still for sale? Will this prop fit on my volvo 250 drive running behind a 302 HM engine? If so I would like to purchase this prop. I am located in the NYC area.

-Dubberstuff

Kirbyvv
07-10-2006, 12:50 PM
Moody:
Got any photo's of the 275T?

Moody Blu'
07-11-2006, 07:02 PM
i can get pics of the 275 T this weekend

the left hand prop is not for sale as of right now, i had a project i was going to do but right now the boat is just sitting there. i tried to get help to do my deck off from people on the forum but everyone thinks im superman even thought i told everyone i just had back surgery.

mike@turnermarinegroup.com
08-10-2006, 02:53 PM
Moody Blu,

I am looking for the prop listed above Michigan Wheel # PR256 or 082063. Your photo of the bronze 14.5 X 24.5 m ight do the trick. 17 spline teeth match. What is hub length? If you have the prop or can tell me where to find my prop let me know .Thanks emeil me.

Mike