View Full Version : Photos needed
DonCig
03-30-2006, 07:53 AM
Can one of the registry members take some pictures of their engines, specifically the following shots from the following engines and send them to me?
Mercury 5.7 or 5.7 LX, vintage 1995-1999.
I need a photo of how Mercury mounted the Mercathode block and the circuit breaker switch to the top of the block.
I am using a Mercury wiring harness from a 1997 5.7LX 4 barrell OK serial number.
Thanks,
Don
mrfixxall
03-30-2006, 09:38 AM
Doncig,, some merc's mounted the circuit braker to the head adove the fuel pump and if i remember the box was mounted to the side of the circuit braker box...
RickSE
03-30-2006, 09:59 AM
Don, you talkin about the red push-button circuit breaker?
If so mine, originally a 2-barrel, was mounted behind the carb on the intake. I had to remount the switch when I changed to a 4-barrel; mounted it off the throttle bracket for the 4-barrel.
Don, if you can wait I can get some this weekend.
Sam
Don you can mount it off engine which I have on many boats, the body does not need ground only the circuits little less mess on the engine. Diagram at the bottom in the link below.
http://www.mercstuff.com/mercathodekit.htm
Phil
farmer tx
03-30-2006, 10:54 PM
Rick do you remember who manufactured the throttle bracket on that engine? I am looking for a bracket like that one.
Thanks,
Mark
RickSE
03-31-2006, 10:47 AM
Mark, It's been a while but I believe I purchased the bracket from Eddie Marine in CA. There are some here:
Throttle Cable Brackets (http://www.eddiemarine.com/cart/catalog.asp?CategoryID=15&CategoryName=Carburetor+Accessories)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.