View Full Version : rub rail
is the factory rubrail 3/4 or the 1 inch was taken off before i got it
To confuse you a little more I think the Taco J aluminum is 1-1/8"
website says 3/4 or 1 inch http://66.98.194.54/tacomarine.com/cgi-bin/ccp51/cp-app.cgi?usr=51G3069690&rnd=2348755&rrc=N&affl=&cip=&act=&aff=&pg=cat&ref=cat2_aluminum_rr&catstr=HOME:rubrail:cat_aluminum_rr
Ok went out to the shop, it is 1-3/16 overall. But measuring from the inside of the J it is 1".
Phil
Ok went out to the shop, it is 1-3/16 overall. But measuring from the inside of the J it is 1".
Phil thank you verry much have a great day now i know what to order
Just looked at the bill for mine it is TACO# A11-0152
Just looked at the bill for mine it is TACO# A11-0152any installing or layout tips got a heat gun
tmdog
03-25-2006, 04:24 PM
Lee , remove the old rub rail and fill allthe holes that were used. Holes on new rail never match the old. Get first rail and mark center. That is going to be placed at the center of the bow, your starting point. Dry fit the rail and shift R or L to clear any obstacles. like screws holding the hull together. It's best you have a helper but not necessary. No heat gun is needed only a good mallet. When you bend around the bow , use hand pressure and bend the rail w/ the mallet slowly around the bend. Instead of doing all this typing, give me a call 770-886-8859 and I will better explain. Jim
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.