Gauge Bezels !?!

[Patrik Sweden]

A dum question maybe, but do you know if it's possible to change the Gauge Bezels on my original Donzi Gauges? (see picture)

I liked these:

http://www.rickracers.com/index.php?cPath=51_643

And another probably even dumber question... What are the sizes I need? (you know.. we have metric system here in sweden) :bonk: :bonk:


:sweden:

[mrfixxall]

yes its possible,it would look better with a gafferig or livorsi guage...Its hard to tell by the pic but the tach and speedo should be 3 3/8 the smaller guages should be 2 5/8...

[Patrik Sweden]

Ok thanks!

But.. I mean just the ring around the gauge, I believe it's called Bezel (?)

I don't want to buy all new Gauges, the Gaffrig/Livorsi is so damn expensive!

[mrfixxall]

gafferig guage

speedo only 120.00

tach 0-6000 rpm 140.00

oil,temo,volt, fuel trim, 270 deg sweep 60.00ea

by the way the should be 2'' the ring 2 5/8 od

[Patrik Sweden]

Do I need to replace all senders!?

Were can I buy it online?

[Greg K]

Do I need to replace all senders!?
Were can I buy it online?
mrfixall is referring to www.gaffrigperformance.com
Changing the senders...depends on brand or type of gauge and the signal required.
for the angled bezels...here is the page.. http://www.gaffrigperformance.com/Products/accessories.cfm?theSubCategory=5
For flat bezels... http://www.gaffrigperformance.com/Products/accessories.cfm?theSubCategory=6
you'll want the 2-1/16 inch i.d. for the small gauges and 3-3/8 inch i.d. for the larger gauges. make sure youhave the clearance also for the o.d. of these bezels.
Now if you're wanting to change the black rims to a different color, you're probably out of luck unless you find some to match the brand of gauges you already have.